Make your own: Fancy Feast Alcohol Backpacking Stove - Andrew Skurka (2024)

I received my first Fancy Feast stove from Ryan Bozis (aka Major Slacker), who attended one of my presentations in Virginia in Spring 2006. I of course thanked him for it, but given how simple the stove was, I could not imagine that it was better than the stove that I had used for most of my Sea-to-Sea Route hike, a complex double-walled open jet model made from Red Bull cans.

But then I tested it against my original stove and several other designs, and I found that it was the fastest and most fuel efficient of them all. Moreover, it was slightly lighter than the other designs; its simple design meant it involved fewer materials, less time, and hardly any expense; it doubled as its own pot stand, which helped to simplify my whole cook system; and it did not require any pre-heating. I have been using this model since Summer 2006.

Make your own: Fancy Feast Alcohol Backpacking Stove - Andrew Skurka (1)
Complete stove setup, with windscreen opened to show stove. This particular stove has been used for 300+ meals. The soot on the pot is from open fires, not from the stove.

Key Specs and Advantages

  • Weighs just .3 oz (about 10 grams)!
  • Costs about $.50 for the cat food can with tax, and $3-$5 for the hole punch.
  • It will never clog, and there are no moving or delicate parts that can break. Even if it is accidentally squashed, there is a chance that it can be re-shaped and used again.
  • Serves as a pot stand, which means you’ll have one less thing to carry.
  • Burns denatured alcohol, a cheap and widely available fuel that can be purchased at hardware stores (in the paint department), gas stations (HEET gas-line antifreeze), and hiking hostels. You can also use Everclear, or grain alcohol, though this is more expensive. Denatured alcohol can be stored in plastic bottles from Platypus or any drink company (e.g. Pepsi).
  • Uses about .6 oz of alcohol to boil about 1.5 cups of water, depending on your pot, the starting temperature of the water, and the efficiency of the windscreen. The water will boil within 5-7 minutes.

Disadvantages

  • Because the stove is only 2.5 inches in diameter, larger pots may not be stable enough. In this case, it might be better to substitute the Fancy Feast can for a larger can, like a tuna fish can.
  • Because this stove is a side-burner, smaller pots (e.g. 600 ml mugs) may not receive enough of the flame. In this case, it’d probably be more efficient to make a top-burner model instead.
  • It does not have a simmer feature, i.e. there is no control over the flame output. This will not be a problem if the extent of your backcountry cooking skills is boiling, which is the only thing necessary if you are content (like I am) with meals based around angel hair pasta, couscous, dehydrated and freeze-dried foods, potato flakes, soups, etc.
  • There is no OFF switch. The stove will burn until there is no more fuel to burn, unless it is smothered with a pot/mug, dirt, or water. It is extremely difficult, though possible, to blow the stove out.
  • It is not as fast as a white gas or canister model. If eating dinner 2-3 minutes earlier is important enough to you that you are willing to carry at least an extra half-pound, by all means… Personally, while I’m waiting for the water to boil, I stretch out, look at tomorrow’s maps and guidebook sections, put together tomorrow’s food, or finish setting up my shelter.

Necessary Supplies

3-oz Fancy Feast cat food can, or another can of the same size. I can usually find the Fancy Feast knock-off brand for $.39 at my local grocery store.

1-hole punch. A standard hole punch is adequate, but an arts & craft model that has a bigger reach is easier to use. With my pole punch I can punch holes 2 inches from the edge of a can or paper sheet, whereas with a standard hole punch I’d be limited to about .75 inches.

Make your own: Fancy Feast Alcohol Backpacking Stove - Andrew Skurka (2)

Step by Step Directions

Watch the video!

1. Remove the cat food and wash out the can.

2. Flatten the sharp edge that was left by the lid with the hole punch (or another hard object, like a butter knife), in order to avoid being cut.

Make your own: Fancy Feast Alcohol Backpacking Stove - Andrew Skurka (3)

3. Just below the lip of can, make one complete row of hole punches. Avoid breaking the tin between the holes by keeping them far enough apart – about one-eighth of an inch.

Make your own: Fancy Feast Alcohol Backpacking Stove - Andrew Skurka (4)

4. Below the first layer of hole punches, make another row of holes. The middle of the bottom holes should be directly underneath the 1/8-inch gaps between the upper holes.

Make your own: Fancy Feast Alcohol Backpacking Stove - Andrew Skurka (5)

5. Make a windscreen, following another one of my articles. A windscreen MUST be used with this stove. Otherwise you will struggle to get a boil, especially in windy conditions.

Operating Instructions

This stove is extremely easy to use. Pour denatured alcohol into the stove, light the alcohol with a match, wait 20-30 seconds for the fuel to warm up, and then put your pot on top of the stove.

I typically boil slightly less water than my meal actually requires but optimum consistency/texture. Once the food has absorbed all of the water I boiled, I then add non-boiled water until the correct consistency is achieved. This has a few advantages: I use less fuel, I never end up with “couscous soup,” and I do not have to wait for my dinner to cool because the non-boiled water cools it down enough to eat right away.

Make your own: Fancy Feast Alcohol Backpacking Stove - Andrew Skurka (6)

Variations

The 3-oz Fancy Feast stove is ideal for a 1-person cook system with a ~1-liter-ish pot. Personally, I use a .9-liter Evernew titanium pot, which has a 5-inch diameter bottom. If you plan to use a larger pot, and you are concerned about the pot being unstable on the 2.5-inch diameter Fancy Feast can, you can follow the same instructions as above but substitute the Fancy Feast can for a larger can, like a tuna fish can.

I have never done tests to prove it, but it’s reasonable to think that the number of hole punches affect the heat output and the fuel efficiency of the stove. With more holes, the stove probably burns hotter and less efficient. With fewer holes, the stove probably burns less hot but more efficient. The optimum number of holes is probably a function of the pot (its material, thickness, and shape), the quantity and starting temperature of water being boiled, and the performance of the windscreen…in other words, too many other variables to make this sort of testing worthwhile.

Video

Make your own: Fancy Feast Alcohol Backpacking Stove - Andrew Skurka (2024)
Top Articles
Latest Posts
Article information

Author: Duane Harber

Last Updated:

Views: 6262

Rating: 4 / 5 (51 voted)

Reviews: 90% of readers found this page helpful

Author information

Name: Duane Harber

Birthday: 1999-10-17

Address: Apt. 404 9899 Magnolia Roads, Port Royceville, ID 78186

Phone: +186911129794335

Job: Human Hospitality Planner

Hobby: Listening to music, Orienteering, Knapping, Dance, Mountain biking, Fishing, Pottery

Introduction: My name is Duane Harber, I am a modern, clever, handsome, fair, agreeable, inexpensive, beautiful person who loves writing and wants to share my knowledge and understanding with you.